BECKHOFF New Automation Technology

Fieldbus Components

Drive Technology

TX1200 | TwinCAT PLC

TX12xx | TwinCAT NC

TX1250 | NC PTP

TX1270 | TwinCAT CNC

Axis Compensation

Axis Commissioning

Channel Parameter

Overview of all channel parameters

General description

Configuration of PLC functions

Dimensional units and resolutions

Settings for tool management

Settings for edge banding

Settings for measurement

Main program modal validity of P-parameters (P-CHAN-00067)

Single step operating mode (P-CHAN-00015)

Settings for diameter programming (P-CHAN-00091)

Settings for circle center point correction and radius compensation

Settings for RESET

Maximum channel override (P-CHAN-00056)

Sampling of Override (P-CHAN-00065)

Mode ofthe Override

Mode of PLC command feed (P-CHAN-00102)

Settings for vector dynamic limits (vector.*)

Configuration of effector coordinate system(ECS)

Tracking of a rotator axis

Switching the default feed axis (P-CHAN-00096)

Valid deceleration at FEEDHOLD (P-CHAN-00097)

Switching of the meaning of M-Functions (P-CHAN-00098)

Effectiveness of tool compensation data (P-CHAN-00100)

Suppression of warnings during contour masking (P-CHAN-00021)

Configuration of the path axes

Configuration of spindles

Settings for synchronous operation (synchro_data.*)

Default coupling specifications (synchro_data.koppel_gruppe[i].*)

Parametering of the protocoling of decoder changes (aep.*)

Definition of symbolic character strings (makro_def[i].*)

Configuration with tool radius compensation (P-CHAN-00092)

Configuration of syntax check (syn_chk.*)

Parametering of kinematic transformation for 5-axis-machining

Initialization at program start (prog_start.*)

Reduction of tangential transition speed (P-CHAN-00009)

Check of jerk on polynomial path (P-CHAN-00110)

Mode for jerk limiting at block transition (P-CHAN-00117)

Speed limit look ahead (speed_limit_look_ahead.*)

Settings for manual mode

Exclusivity of dimension programming (P-CHAN-00116)

Exclusivity of axes programming (P-CHAN-00148)

Sub program call with M6 (P-CHAN-00118)

Sub program call at program start (P-CHAN-00119)

Settings for software limit monitoring

Display format during machining simulation (P-CHAN-00121)

List interpretation during active NC program (P-CHAN-00146)

Adoption of block number at sub program call (P-CHAN-00150)

Parameterisation of HSC machining (hsc.*)

Channel synchronization during axes exchange(P-CHAN-00154)

Program name for automatic streaming (P-CHAN-00158)

Modal effect of I/J/K for circle programming (P-CHAN-00159)

Sub programm calls by the use of G functions

Active testing whether axis group is "in position"(P-CHAN-00173)

Definition of channel display information

Default axis configuration in the channelafter reset(P-CHAN-00179)

Suppressing display of file name/offset (P-CHAN-00180)

Ignore internal stop conditions during rapid contour visualization (P-CHAN-00183)

Orientation programming (ori.*)

Path dependend dynamic weighting

Cycle programming settings

Clamp Position Offsets

External Variables

Manual Mode Parameter

System parameters

Kinematic Transformation

PLC library McpPLCopenP1

Function Description

TSxxxx | TwinCAT Supplements

Industry Solutions

Home