Overview of parameters
ID | Description |
|---|---|
Setting the default measurement type | |
Valid deceleration ramp at feedhold | |
Error response with measurement type 1 | |
Active delay with measuring signal | |
Error response with measurement type 7 | |
Active dynamic for measurement run |
ID | Description |
Number of real-time bit used for SERCOS drives | |
Measuring probe stroke | |
Axis can be used as measurement axis. | |
Measurement feed rate in accordance with measurement type 2 | |
Permitted path after target point | |
Measurement methods | |
Number of probing input | |
Relevant measurement edge | |
Position lag limit for fixed stop detection with Measuring travel to fixed stop | |
Minimum time in µs for fixed stop detection with Measuring travel to fixed stop | |
Minimum path to activate fixed stop detection with Measuring travel to fixed stop | |
Minimum distance to activate fixed stop detection with Measuring travel to fixed stop, specified in per thousand of block length | |
Maximum permitted position change during fixed stop detection with Measuring travel to fixed stop | |
Slave axes to detect a fixed stop during Measuring travel to fixed stop |
Position lag limit | |
Number of position control cycles |
Probing signal edge | |
Consider external probing signals | |
Read in the probing signal with SERCOS | |
Measuring probe signal via hardware interface | |
Measured value detection in the CNC | |
Measurement with Move to fixed stop |