Installing the incremental encoder (type 2420)

If the stepper motor is ordered with the incremental encoder, the motor and the encoder are fitted in the factory. Retrospective installation of the encoder is only possible, if the stepper motor was ordered with a second shaft end and a hole for the locating pin. The locating pin provides torque support and must be secured with industrial adhesive (e.g. Loctite).

 

Installing the incremental encoder (type 2420) 1:

Installing the incremental encoder (type 2420) 2:

Install the encoder with clutch on the shaft

Carefully tighten the clamping hub

Further Information