Simulation settings

To test the behavior of the movers virtually, you can create a simulation. There are three possible settings for the movers in this simulation:

Selection of a part
Determination of a precise position
Using a mover as Mover 1

►In the drop-down menu Part select a part on which the mover is to start

►Enter a value for the exact position of the mover on the part at Position

If the MoverIdDetection is activated, the value in the input field ID defines whether the XTS Mover is created as Mover 1. Otherwise the input field ID remains without an entry.

►Enter a mover ID in the input field ID

►Make sure that the number of IDs defined matches the settings of the Parameters (Init) tab under the Processing Unit object.