During operation

Observe the GND concept

Special conditions need to be observed for the grounding of the XTS. Be sure to read the chapter "Grounding of the supply".

Do not work on live electrical parts

Ensure proper connection of the protective conductor. Never loosen electrical connections when live. Only work on the XTS when the voltage has dropped to < 10 V. Disconnect all components from the mains and secure them against being switched on again.

Do not touch hot surfaces

Check the cooling of the surfaces with a thermometer. Do not touch the components during and immediately after operation. Allow the components to cool sufficiently after switching off.

Avoid overheating

Operate the components according to the technical specifications. Refer here to the chapter: "Technical data". Provide for sufficient cooling. Switch the components off immediately if the temperature is too high.

Do not touch any moving or rotating components

Do not touch any moving or rotating components. Fasten all parts or components on the machine or plant.