Mover

The following Beckhoff movers are approved for EcoLine motor modules:

• AT8300-1x00-0100
• AT9011-0050-x550
• AT9011-0070-x550
• AT9012-0050-x550
• AT9014-0055-x550
• AT9014-x070-x550

A 5-pin magnetic plate set AT9001-0550 or AT9001-1550 must be fitted to the mover.

The distance between two movers [1] must be 70 mm on straight EcoLine modules, regardless of the mover type. The distance is measured at the center of the coils [2].

Note the requirements for No Cable Technology If you are using movers with NCT electronics fitted, you must observe the requirements for No Cable Technology. Further information can be found in chapter NCT | No Cable Technology.