During operation

Observe the GND concept

During the installation, follow the common guidelines for grounding electrical components. For grounding please refer to the chapter on Grounding the machine bed.

Do not work on live electrical parts

Ensure that the protective conductor and functional conductor are properly connected. Never loosen electrical connections when live. Disconnect all components from the mains and secure them against being switched on again.

Do not touch hot surfaces

Check the cooling of the surfaces with a thermometer. Do not touch the components during and immediately after operation. Allow the components to cool sufficiently after switching off.

Avoid overheating

Operate the components according to the technical specifications. Refer here to the chapter: "Technical data". Provide for sufficient cooling. Switch the components off immediately if the temperature is too high.

Do not touch any moving or rotating components

Do not touch any moving or rotating components. Fasten all parts or components on the machine or plant.