Stator surface

Notice

Damage to the stator surface caused by small magnetic parts

Do not allow any small magnetic parts, such as washers, metal shavings, or metal dust, to get onto the stator surface. Movers can attract and pick up small magnetic parts. Small magnetic parts adhering to the mover can damage the stator surface and cause a system failure.

  • Check the stator surface of the tiles and the underside of the movers for small magnetic parts. Remove contaminants and small parts immediately.
  • Always keep the system and its surroundings clean.

Notice

Damage to the stator surface due to mechanical stress

Do not place any tools or objects with sharp, pointed, or small contact surfaces on the stator surface or press them against it. Point loads or loads applied by sharp edges can damage the stator surface and the coils beneath it.

  • Do not place any sharp-edged tools or objects on the stator surface.
  • Do not press any sharp-edged tools or objects against the stator surface.

The stator surface of the tiles must not be damaged. Damaged tiles must be replaced immediately. Avoid:

For assembly steps and press-fitting operations, suitable fixtures must be installed to absorb the resulting forces, either through the mover or at locations outside the stator surface. Perform press-fitting operations only on tool carriers that have been set down. Further information can be found in chapter Press-in processes and pressing positions.