Settings

Light settings

Phys. minimum value lamp

Physical minimum value as a DALI value that all the lamps used support. In case of different minimum values, always specify the largest.

Dimming time

Time required to dim from the minimum to the maximum value.

Fade time

The fade time specifies the speed at which the luminous intensity should be changed.

1: 357.796 steps/s

2: 253.000 steps/s

3: 178.898 steps/s

4: 126.500 steps/s

5: 89.449 steps/s

6: 63.250 steps/s

7: 44.725 steps/s

HCL

Activates HCL (Tunable White).

Enable scenes

Enables scenes control.

Light mode control

Starting value

The Dali value at which the lamps in the group start when the Daylight Control is activated.

Large brightness difference

If the difference between the setpoint and actual value is larger than the set value, "Dead time large difference" is used, otherwise "Dead time small difference".

Dead time small Difference

Dead time between the individual Dali commands with which the lamp level is changed if the brightness difference is small.

Dead time large Difference

Dead time between the individual Dali commands with which the lamp level is changed if the brightness difference is large.

Switch-off value/bright enough

If the brightness value around the switch-off value is larger than the setpoint, the group will be switched off after the switch-off time. During that time, however, the Daylight Control can still dim to the "lowest value".

Switch-off time if bright enough

Time period until the group is switched off when the switch-off value is reached.

Hysteresis

Control hysteresis around the setpoint. If the actual value ± of the hysteresis lies around the setpoint, the lamp value will not be changed.

Lowest value

The Dali value down to which the lamps should be dimmed. This must be greater than or equal to the "Phys. minimum lamp value".

Set global group values

The settings described below are made only after actuating the respective button. The values are written for all groups. However, you can block individual groups from this in the Groups.

Time setting

You can set the time manually and activate it with the Set button, or retrieve it automatically from a time server. To do this, enter the address of the time server and activate it by clicking on the Set button.

Buildings

Name

Text entry top left. e.g.: Story designation

Longitude

Necessary for sunrise/sunset calculations for HCL.

Latitude

Necessary for sunrise/sunset calculations for HCL.

Energy measurement

Enables energy measurement and data logging in csv format.

Push button

Push button enable start page

Activates the display of the first 24 push buttons on the Start page.

Note Push buttons can be operated without login/rights!

Exceptions for the following groups

Up to 4 groups can be selected that are not affected by the central-off of a push button. Particularly helpful for corridor lighting.

Reset push buttons

All push buttons are reset at the start time. Groups switched by push buttons are switched off if no other event (presence, schedule) is pending.

Language

German, English, Finnish, Swedish, Dutch, French, Spanish

Note Terms that have not yet been translated are in English!

Data backup

Basic settings

A dialog opens when the Save or Load button is pressed. In this dialog you enter the PIN (default: 1909). After correct entry, the buttons for saving and loading appear. The procedure can take a while depending on the project size.

Factory settings

A dialog opens when the Save or Load button is pressed. In this dialog you enter the PIN. After correct entry, the buttons for saving and loading appear. The procedure can take a while depending on the project size.

USB Export/Import

Exports the data from the controller to the USB flash drive,

Imports the data from the USB flash drive to the controller.

The data are not automatically loaded/enabled. Use the basic setting Load.

CX Config

This button only works on a touch panel (e.g. CP6606). Can be used for general device settings relating to FTP, firewall etc.