Parameterisation
Required input parameters
Input parameters | Description |
@P1 | Reference plane (absolute) |
@P2 | Retraction plane (absolute) |
@P3 | Safety clearance in Z (relative to reference plane/machining height) |
@P4 | Depth (relative to reference plane) |
@P5 | Maximum infeed in Z |
@P6 | Maximum infeed in XY (Maximum V.G.WZ_AKT.R is recommended to avoid residual material) |
@P35 | Reference cycle 1: SysMillContourPocket.ecy 2: SysMillContourSpigot.ecy |
@P36 | Tool radius used in the reference cycle |
@P50 | Identification number of the pocket or blank contour |
Optional input parameters
Input parameters | Description |
@P7 | Pitch of plunge helix Default value = 10% of tool radius |
@P8 | Radius of plunge helix Default value = 50% of tool radius |
@P15 | Finishing allowance at base in reference cycle Default value = 0 |
@P16 | Finishing allowance at edge in reference cycle Default value = 0 |
@P20 | Feed rate for roughing for milling in the XY plane (specified in mm/min, inch/min) |
@P21 | Feed rate for roughing in Z (specified in mm/min, inch/min) |
@P30 | Machining direction "ClimbMilling" or 0: Down milling (default) "UpCutMilling" or 1: Up milling |
@P32 | Feed mode in Z 1: vertical (default value) 2: helical |
@P184 | Maximum path in idle before tool is retracted. Idling occurs when the milling cutter is positioned at machining height at the programmed feed without removing material. This parameter defines the idling distance as of which the milling cutter is retracted and repositioned. The default value is five times the tool diameter. Available as of CNC Build V3.1.3121.0. |
@P51 | Identification number of an island contour |
@P52 | Identification number of an island contour |
@P53 | Identification number of an island contour |
@P54 | Identification number of an island contour |
@P55 | Identification number of an island contour |
@P56 | Identification number of an island contour |
@P57 | Identification number of an island contour |
@P58 | Identification number of an island contour |
@P59 | Identification number of an island contour |
@P60 | Identification number of an island contour |
Parameters which mainly refer to the Z axis are displayed in the graphic below:
It is recommended to use the Syntax check to verify whether the input parameters are correctly assigned.
