General

Notice

The tool diameter may not be greater than the distance between the laser transmitter and receiver.

Notice

During the cycle, all active offsets must be suppressed using #SUPPRESS OFFSETS except for tool offsets to ensure uniform positioning during calibration and measuring.

The 3 files must be present and configured before use, otherwise the cycles cannot run.

  1. SysCalibConfigLaser.nc
  2. SysCalibConfigLaserOn.nc
  3. SysCalibConfigLaserOff.nc

Depending on the parameters, a machine stop is executed in the event of a tool breakage or a warning with the error message P-ERR-13461 is output.

If wear exceeds the specified tolerance, the machine is stopped depending on the parameters or a warning with the error message P-ERR-13450 is output.