General

A axis is the designation for the rotary axis about X.

B axis is the designation for the rotary axis about Y.

C axis is the designation for the rotary axis about Z.

	The SysCalibConfigTouchprobe.nc file is not used for manual teach-in.

If no measuring signal is triggered during the measurement, the machine stops with the error message: “No workpiece detected, please check your measuring section.“

P-ERR-13413

If a measurement is detected during positioning, the machine stops with the error message: “Collision on positioning, please check your motion range.“

P-ERR-13414

The SysCalibConfigTouchprobe.nc file must be present and configured before the cycles are used, otherwise the cycles cannot run.

At the end of the cycles, a file is written CS_BASE_[CS ID @P39].bcs.

Notice
If the file already exists, it is deleted and a new file is written. No back-up is made!

From then on, the file can be called from any program.

The generated program defines the required coordinate system (CS) and enables it immediately.