State graph of operation modes

Note: There is no state graph for the “Standby“ operation mode.

State graph of operation modes 1:
State graph of an operation mode

A CNC reset is automatically executed when the target operation mode and target state are commanded if the state change specifies an abort (see “abort”).

The error state is exited by an automatically executed reset if an operation mode was commanded.

In addition, a CNC reset can be forced by the following commands:

a) Select operation mode = STANDBY and state = SELECTED

b) Explicit specification of transition = RESET in the currently active operation mode

c) Specify the target state = RESETTING (see below)