ID 20495

Positive manual mode offset must not be negative.
Description	When programming the NC command #MANUAL LIMITS[...] or #SET OFFSET[…], the positive offset limit is defined with a negative value inside the square brackets. For further information see [PROG// Section: Manual operation mode – Presetting offset limits] Syntax example: Wrong: N10 #MANUAL LIMITS [AX=X NEGATIVE=-5.0 POSITIVE=-5.0] Correct: N10 #MANUAL LIMITS [AX=X NEGATIVE=-5.0 POSITIVE=5.0]
Response	Class		2	Abort NC program processing.
Solution	Class		3	Check and modify NC program. The positive offset limit must be programmed with a positive value inside the square the square brackets.
Parameter	%1:	Error value [-]
		Value of the positive offset limit
Error type	1, Error message from NC program.