Problems with the block diagram representation in TwinCAT XAE

TcCOM modules created with the TwinCAT Target for Simulink^® version 2.x.xxxx.x and higher require a TC3 BlockDiagram version 1.4.1419.0 and higher for correct display in TwinCAT XAE.

Where can I find the version of the TC3 BlockDiagram?

• Under Programs and Features in the Control Panel > Beckhoff TwinCAT 3 BlockDiagram.
• In the block diagram in TwinCAT XAE > right-click in the window > About TC3 BlockDiagram.

If your TwinCAT XAE installation contains an earlier version of the TC3 BlockDiagram:

• Can you install the TwinCAT Tools for MATLAB and Simulink setup. This includes a new TC3 BlockDiagram version.
• You can contact Beckhoff support to request a separate TC3 BlockDiagram setup.