SCIT_ControlActiveConfiguration

VAR_INPUT

VAR_INPUT
    NETID        : T_AmsNetId;
    PORT         : T_AmsPort;
    WRTRD        : BOOL;
    TMOUT        : TIME := DEFAULT_ADS_TIMEOUT;
    SWITCH_CODE  : WORD;
    DEVICE_NO    : WORD;
END_VAR

NETID: The network address of the computer in which the card is installed can be entered here (type: T_AmsNetID). If the card is located within the same system, it is also possible to give an empty string.

PORT: Contains the ADS port number of the card that was assigned by the TwinCAT system (type: T_AmsPort).

WRTRD: The function block is activated by a positive edge at this value.

TMOUT: Maximum time allowed for the execution of the command.

SWITCH_CODE: Indicates the action that is to be executed with the device:

0 = Segment Off

1 = Segment On

2 = Device_Off

3 = Device_On

4 = Device_Disable

5 = Device_Enable

DEVICE_NO: Specifies the device number of the addressed device. For example, device 3.1 requires a value of 16#0301 to be given.

VAR_OUTPUT

VAR_OUTPUT
    BUSY       : BOOL;
    ERR        : BOOL;
    ERRID      : UDINT;
    RESULT     : WORD;
    ADDERRINFO : WORD;
END_VAR

BUSY: After activation of the function block the busy signal remains asserted until an feedback is received.

ERR: If an error occurs while the command is being transferred, the ERR output is set once the BUSY signal is cancelled.

ERRID: Returns the ADS error number in the case of error.

RESULT: Returns the result from the card (provided that fault-free ADS transport has occurred (ERR = FALSE)). RESULT = 0 identifies successful execution of the command. A value other than 0 contains the error number from the Phoenix card.

ADDERRINFO: If feedback from the card is negative, this contains additional error information (cf. the Phoenix card error descriptions).

Requirements