Slave positions outside the modulo range

If the gear ratio between the master and slave is to be very large, it may be necessary to define slave positions that lie outside the modulo range. This is why slave positions outside the modulo range are not transformed into it but are used without change as an interpolation point. The following figure shows such a table, and the profile thus run through.

Tablename = extremetable4 # Table name
Table-ID = 414 # Table ID
Tabletype = 7 # Table type
Functiontype = 5 # Type of interpolation
Lines = 8 # Number of lines
Begintable # Begin of table
0 0
200000 0
900000 -500000
1800000 -10000000
2100000 -16000000
2700000 -12000000
3200000 -19000000
3400000 -20000000
EndTable

Slave positions outside the modulo range 1: — Figure 1-12: Table with large transformation, endless negative.