Terminals and wiring

The terminals are designed to be finger-safe according to IP20 and are suitable for field and factory wiring.

Technical data	Input	Output	DC-OK signal
Connection cross-section	e: max. 6 mm² f: max. 4 mm² a*: max 4 mm² (d<2.8 mm)	e: max. 6 mm² f: max. 4 mm² a*: max 4 mm² (d<2.8 mm)	e: max. 1.5 mm² f: max. 1.5 mm² a*: max 1.5 mm² (d<1.6 mm)
Connection cross section (AWG)	e: AWG 20-10 f: AWG 20-10 a* AWG 20-10 (d<2.8 mm)	e: AWG 20-10 f: AWG 20-10 a* AWG 20-10 (d<2.8 mm)	e: AWG 24-16 f: AWG 24-16 a* AWG 24-16 (d<1.6 mm)
Strip length	7 mm / 0.28 inch	7 mm / 0.28 inch	7 mm / 0.28 inch
Screwdriver	3.5 mm slotted screwdriver or Phillips No 1

e* = solid single wire
f* = stranded wire
a* = with ferrule

Wiring instructions:

Use suitable copper cables that are designed for at least the following operating temperatures:
+60 °C for ambient temperatures up to +45 °C,
+75 °C for ambient temperatures up to +60 °C, and
+90 °C for ambient temperatures up to +70 °C.
Observe the national installation rules and regulations!
Make sure that all single wires of a strand are connected to the terminal!
Unused terminals should be tightened firmly.
Ferrules are permitted.

Daisy chaining of outputs

Daisy chaining (jumping from one DC/DC converter output to the next) is permitted as long as the average output current through a connector pin does not exceed 25 A. If the current is higher, use a separate distribution terminal block.