Displaying a cursor
You can have a cursor shown on the display.
The cursor is disabled in the factory settings.
Enabling and configuring a cursor
Set the CoE parameter 8008:19 "Cursor" to one of the following values:
Value | Enum | Cursor on the display |
|---|---|---|
0 (factory setting) | "off" | Cursor disabled |
1 | "on" | The cursor is displayed as a horizontal line under a character. |
2 | "blink" | The cursor is displayed as a blinking rectangle. |
Positioning the cursor
Position the cursor on the display by writing the coordinates in the following CoE parameter:
Coordinates | CoE parameters |
|---|---|
x | 8008:1Ahex "Cursor pos x" |
y | 8008:1Bhex "Cursor pos y" |
If x = 0 and y = 0, the cursor is in the top left corner of the display.