EL2522 - when using older FW or older TwinCAT versions with "Continuous Position" mode

the following must be observed if necessary:

Update of the NC driver
Add axes to the NC
Linking Axis/Drive/nOutData5 to the Target Counter Value of the terminal

a)

EL2522 - when using older FW or older TwinCAT versions with "Continuous Position" mode 1:

b)

EL2522 - when using older FW or older TwinCAT versions with "Continuous Position" mode 2: — Linking Axis/Drive/nOutData5 to the Target Counter Value of the terminal

Link Axis/Drive/nCtrl1 to AutomaticDirection of the terminal

a)

EL2522 - when using older FW or older TwinCAT versions with "Continuous Position" mode 3:

b)

EL2522 - when using older FW or older TwinCAT versions with "Continuous Position" mode 4:

c)

EL2522 - when using older FW or older TwinCAT versions with "Continuous Position" mode 5: — Link Axis/Drive/nCtrl1 to AutomaticDirection of the terminal