Technical data

Analog inputs	EJ3114-0010
Analog inputs	4 (differential)
Signal voltage	±20 mA
Internal resistance	typ. 85 Ω + diode voltage
Resolution	16 bit (including sign)
Sampling type	multiplex
Ground reference	differential
Conversion time (default setting: 50 Hz filter)	approx. 100 µs
Input filter cut-off frequency	5 kHz
Measuring error (total measuring range)	< ±0.1 % (at 23 °C ±5 °C, otherwise < ±0.2 % relative to full scale value)
Surge voltage resistance	35 V_DC
Common-mode voltage U_cm	max. 10 V

Supply and potentials	EJ3114-0010
Power supply for the electronics	via the E-bus
Current consumption via E-bus	typ. 300 mA
Electrical isolation	500 V (E-bus/field voltage)

Function and communication	EJ3114-0010
Distributed clocks	yes
Distributed clocks accuracy	<< 1 µs
Support NoCoEStorage	yes
Configuration	no address or configuration settings required
Special features	Standard and compact process image Activatable FIR/IIR filters Limit value monitoring

General data	EJ3114-0010
Dimensions (W x H x D)	approx. 12 mm x 66 mm x 55 mm
Weight	approx. 30 g
Installation	on signal distribution board
Pollution degree	2
Installation position	Standard
Position of the coding pins	1 and 5
Color coding	green

Environmental conditions	EJ3114-0010
Permissible ambient temperature range during operation	0 °C ... +55 °C
Permissible ambient temperature range during storage	-25 °C ... +85 °C
Permissible relative air humidity	95 %, no condensation
Operating altitude	2,000 m

Standards and approvals	EJ3114-0010
Vibration / shock resistance	conforms to EN 60068-2-6 /EN 60068-2-27 (with corresponding signal distribution board)
EMC immunity / emission	conforms to EN 61000-6-2 /EN 61000-6-4 (with corresponding signal distribution board)
Protection rating	EJ module: IP20 EJ system: dependent on the signal distribution board and housing
Identification / approval^*)	CE

*) Real applicable approvals/markings see type plate on the side (product marking).

	CE approval The CE Marking refers to the EtherCAT plug‑in module mentioned above. If the EtherCAT plug-in module is used in the production of a ready-to-use end product (PCB in conjunction with a housing), the manufacturer of the end product must check compliance of the overall system with relevant directives and CE certification. To operate the EtherCAT plug‑in modules, they must be installed in a housing.