Technical data

Device functions	EJ2564
Application recommendation	General lighting, LED control, multicolor common anode LEDs
Connection technology	2-wire
Number of outputs	4
Input voltage U_IN	5 V_DC...48 V_DC
Load type	LED
Special features	Adjustable values: Color component per channel (duty cycle), Light intensity/brightness for all channels (Master Gain), Frequency (to generate visible flashes or anti-stroboscope), Time for dimming up/down (Ramp Time), Scaling of the output (gamma), Behavior in case of a bus error (Behavior in watchdog case)
Reverse polarity protection	-
Short-circuit proof	-

LED output	EJ2564
Output voltage U_OUT	U_IN
Output current I_OUT	4 A per channel (sum current limit: 15 A with supply via all contacts)
Duty cycle	0 … 100 %
Frequency	1 Hz ... 16 kHz (default: 5 kHz)

Communication	EJ2564
Configuration	via TwinCAT System Manager
Distributed Clocks	-

General data	EJ2564
Current consumption via E-bus	85 mA typ.
Weight	approx. 30 g
Dimensions (W x H x D)	approx. 12 mm x 66 mm x 55 mm
Assembly	on signal distribution board
Installation position	Standard
Position of the coding pins	2 and 6
Color coding	red

Environmental conditions	EJ2564
Permissible ambient temperature range during operation	0 °C ... +55 °C
Permissible ambient temperature range during storage	-25 °C ... +85 °C
Permissible relative air humidity	95 %, no condensation
Operating altitude	max. 2,000 m

Standards and approvals	EJ2564
Vibration/shock resistance	conforms to EN 60068-2-6/EN 60068-2-27 (with corresponding signal distribution board)
EMC immunity/emission	conforms to EN 61000-6-2 /EN 61000-6-4 (with corresponding signal distribution board)
Protection rating	EJ module: IP20 EJ system: dependent on the signal distribution board and housing
Approvals/markings*	CE, UKCA

*) Real applicable approvals/markings see type plate on the side (product marking).

	CE approval The CE Marking refers to the EtherCAT plug-in module mentioned above. If the EtherCAT plug-in module is used in the production of a ready-to-use end product (PCB in conjunction with a housing), the manufacturer of the end product must check compliance of the overall system with relevant directives and CE certification. To operate the EtherCAT plug-in modules, they must be installed in a housing.