EC/ED/EFxxxx wiring with push-in connection technology
| |
Risk of injury through electric shock and damage to the device! Bring the bus terminal system into a safe, de-energized state before beginning to mount, disassemble, or wire the bus terminals! |
Fig.18: Connecting and disconnecting the conductors- 1. Connecting solid conductors and conductors with ferrules (Fig. top left, step 2)
These can be connected using a direct plug-in technique, without tools.
- Insert the conductor into the terminal point after stripping the insulation (2)
- 2. Connect stranded cables (Fig. top right, steps 1–3)
These must be connected via the push-button.
- Use a screwdriver to press the push-button to open the contact point (1).
- Then insert the conductor (2).
- Release the push-button by pulling back the screwdriver to close the terminal point (3).
Disconnect cables (Fig. above steps 4–6)
The release is performed using the push-button for all conductor types.
- Use a screwdriver to press the push-button to unlock the contact (4).
- Then pull out the conductor (5).
- Release the push-button by pulling back the screwdriver to close the terminal point (6).
Notice | ||
 | Observe the permissible connection cross-sections and stripping lengths The permissible conductor cross-section and stripping length depend on the type of housing, please refer to the housing data in the “Technical data” chapter for the device in question. | |