Faults
Please also refer to the Safety instructions section.
Possible faults and their correction
If servicing is required, please quote the project number of your PC (on the type plate).
Please contact your Beckhoff branch office or representative for local support and service on Beckhoff products!
The addresses of Beckhoff's branch offices and representatives round the world can be found on her internet pages:
http://www.beckhoff.com
You will also find further documentation for Beckhoff components there.
|
Fault |
Cause |
Measures |
|---|---|---|
|
no function after the Embedded PC has been switched on |
no power supply
|
1.Check fuse Call Beckhoff support |
|
Embedded PC does not boot fully |
Hard disk damaged (e.g. due to switching off while software is running), incorrect setup, other causes |
Check setup. Call your Beckhoff support |
|
Computer boots, software starts, but control does not operate correctly |
Cause of the fault is either in the software or in parts of the plant outside the Embedded PC. |
Call the manufacturer of the machine or the software. |
|
CF card access error |
faulty CF card, faulty CF slot |
Use a different CF card to check the CF slot Call your local Beckhoff support |
|
Embedded PC only works partially or temporarily |
Defective components in the Embedded PC
|
Call your local Beckhoff support |