Installing a toolboard and handle

You have the option to mechanically extend your device. The following ordering options are available: Follow the links provided to get to the respective product pages with images of the ordering options:

Mechanical extensions

Order identifier

Version

C9900-M361

Handle, length = 386 mm, anodized aluminum

  • ex factory on CP3x12 to CP3x24, mounted on the bottom of a control panel or panel PC
  • for retrofitting for CP3xxx-1600

http://www.beckhoff.com/c9900-m361

C9900-M419

Toolboard for keyboard or tools

  • ex factory on CP3x12 to CP3x24, mounted on the bottom of a control panel or panel PC
  • for retrofitting for CP3xxx-1600

http://www.beckhoff.com/c9900-m419

The ordered extensions are delivered with the device, you must install them yourself afterwards. Install the handle to the bottom of the device using the two M5 screws (see fig. 31).

Installing a toolboard and handle 1:Fig.31: Installing handle

To mount a toolboard on the device, follow the steps below, which are shown in figure 32:

1. Screw the toolboard brackets to the bottom of the device using the three M5 screws (section A).
2. Screw the toolboard to the underside of the bracket using the four M5 screws (section B).
3. Screw the two strain reliefs to the underside of the toolboard using the two M4 screws (section C).
You have mounted the toolboard on the device.
Installing a toolboard and handle 2:Fig.32: Installing toolboard