Installation in the control cabinet
When installing in the control cabinet, note that there must be 5 cm of free space above and below the device for ventilation.
Mounting via mounting plates
In order to mount the Industrial PC by its rear or side panel in the control cabinet using the mounting plates, the control cabinet must be equipped with drill holes for the fastening screws corresponding to the dimensions of the PC (see chapter 4.2.1 Dimensions). You need M4 screws for mounting.
After you have drilled the holes for the fastening screws in the control cabinet, you can mount the Industrial PC in the control cabinet with the mounting plates. If your device is equipped with additional plug-in card slots, the device and thus the mounting plates are wider. However, the mounting procedure is the same.
To install the industrial PC in the control cabinet, follow the steps below:
- 1. Place the fastening screws in the drill holes in the rear panel of the control cabinet.
- 2. Hang the PC on the screws at the marked points of the mounting plate (see Fig. 16).
- 3. Tighten the fastening screws.
- You have successfully installed the industrial PC in the control cabinet.