Control cabinet installation
The C6015 Industrial PC is designed for mounting in control cabinets in machine and plant engineering applications. The environmental conditions specified for operation must be observed (see chapter 9 Technical data).
Using different mounting plates, you can align the cable entry based on the application requirements.
Figure 8 shows the three available mounting plates: standard mounting plate 1, optional mounting plate 2, and optional mounting plate 3 with DIN rail adapter. In all cases, the plate is attached to the right-hand side wall of the industrial PC with four Torx TX10 screws and a tightening torque of approx. 0.5 Nm. You can turn all mounting plates before fastening them such that the PC can be mounted in the desired orientation for the cable entry in the control cabinet (see Chapter 4.2.1 Mounting options).
The basic version of the industrial PC is supplied with the standard mounting plate 1 already mounted as shown in Fig. 8. The scope of delivery does not include any further mounting plates. You can choose the following ordering options:
Order identifier | Design |
|---|---|
C9900-M664 | Mounting plate for C601x on the side wall, instead of the standard mounting plate |
C9900-M665 | Mounting plate for lateral mounting of the C601x, single part, not mounted |
C9900-M666 | Mounting plate with DIN rail adapter for C601x, instead of the standard mounting plate |
C9900-M667 | Mounting plate with DIN rail adapter for C601x, single part, not mounted |