Documentation issue status

1.27

• From this version the BX can also be used without K-bus terminals, if none are configured in the System Manager; no error will be generated

1.20

• support of TwinSAFE terminals; only one logic terminal is permitted at the K-bus, with a maximum of seven connections
• Switching of the COM 2 interface between RS232 and RS485 modified
  
  ATTENTION
  Firmware 1.20 does not run on older hardware versions (lower than 3.5). Please take the hardware version of your BX Controller from its sticker

1.17

• New: Support of persistent data
• Forcing and reading of the TwinCAT configuration corrected
• CFC tool is supported as in firmware 1.14 and lower

1.16

• Online change problem rectified for large projects
• New: Display backlight can be switched off
• New: Boot project CRC display can be enabled during booting
• REAL_TO_STRING: Real variables, e.g. 9.0, are now output as string in this form, i.e. '9.0' (previously '9.')
• TC-Config: 4-way and 8-way analog terminals fixed

1.14

• K-bus updated
• CAN slave interface updated
• SSB reset of the SSB implemented
• Generic function implemented
• Non-implemented features are disabled with the System Manager, Build 1303.
• Writing of outputs is possible with TwinCAT Build 1302
• Optimization of the terminal verification in a TwinCAT configuration
• The TC-Config supports KL1212
• The TC-Config supports KM modules

1.14

• K-bus updated
• CAN slave interface updated
• SSB reset of the SSB implemented
• Generic function implemented
• Non-implemented features are disabled with the System Manager, Build 1303.
• Writing of outputs is possible with TwinCAT Build 1302
• Optimization of the terminal verification in a TwinCAT configuration
• The TC-Config supports KL1212
• The TC-Config supports KM modules

1.09 / 0.99i

• Code optimization, resulting in a performance enhancement of around 30%
• Optimization of TcComPortBX.lbx - Fb_BX_BK8x00_slave improved diagnostics
• NEW: CFC client support implemented (Controller Flash Copy client)

1.08 / 0.99h

• SSB optimization

1.07 / 0.99g

• Serial ADS optimization
• Online change optimization

1.06 / 0.99f

• COM 1 serial ADS optimization

1.05 / 0.99e

• If a PLC reset is triggered too soon after an online change, an error message is issued saying that the service is not yet ready.
• Optimization at the SSB
• Disabling of the red PLC cycle monitoring LED

1.04 / 0.99d

• Loading and storing of recipes, new function in TcSystemBX fb_ReadWriteFile
• Optimization: TcComPortBX, FB_BX_COM_64ex

1.01 / 0.99a

• From PDO 5, up to PDO 32 can be activated in the default configuration
• If the boot project is created immediately after an online change, an error message is issued saying that the service is not yet ready.

1.00 / 0.99

• Fieldbus diagnostics implemented in TwinCAT configuration