Parameterization of the Bus Coupler using DIP switches
The following parameterizations can be carried out without using configuration software, with the aid of the DIP switches and the end terminal (KL9010).
This paramétrisation mode is only active if only one end terminal (KL9010) is inserted. Otherwise, the normal settings apply.
Restoring the manufacturer's settings
- Switch the Bus Coupler off and then append the end terminal (KL9010).
- Set all the DIP switches to ON, and switch the Bus Coupler on again.
- Once the default parameters have successfully been set, the Error LED lights, and the I/O RUN and I/O ERR LEDs flash alternately.
- You can then switch the Bus Coupler off, connect the Bus Terminals, and continue as usual.
Deleting the boot project (BC9000 only)
- Switch the Bus Coupler off and then append the end terminal (KL9010).
- Set DIP switches 1 to 9 to ON, DIP switch 10 to OFF, and switch the Bus Coupler on again.
- Once the boot project has been successfully deleted, the I/O RUN and I/O ERR LEDs flash alternately.
- You can then switch the Bus Coupler off, connect the Bus Terminals, and continue as usual.
Setting the Ethernet parameters
- Switch the Bus Coupler off and then append the end terminal (KL9010).
- Set all the DIP switches to OFF, and switch the Bus Coupler on again.
- The I/O RUN and I/O ERR LEDs light steadily.
- Make the desired setting in accordance with the following table.
|
DIP switch |
Parameter |
Selection |
Setting |
Comment |
|---|---|---|---|---|
|
1 |
Baud rate |
10 MBaud |
OFF (0) |
|
|
100 MBaud |
ON (1) |
Default | ||
|
2 |
Auto-Baud-Rate |
Disable |
OFF (0) |
|
|
Enable |
ON (1) |
Default | ||
|
3 |
Transmission type |
Half duplex |
OFF (0) |
|
|
Full duplex |
ON (1) |
Default |
- To accept the values, set DIP switch 10 to ON.
By flashing the I/O RUN and I/O ERR LEDs the Bus Coupler indicates that it has accepted the parameters. - You can then switch the Bus Coupler off, connect the Bus Terminals, and continue as usual.