6080, Failure config bits
A failure in the internal configuration happened.
|
Diagnostic Code (Hex.) |
Diagnostic Code (Dez.) |
|---|---|
|
6080 |
24704 |
|
Class |
Type |
|---|---|
|
Error |
Error |
|
Standard Reaction |
Reset |
|---|---|
|
PSM is not ready to operate and transition PREOP to SAFEOP disabled |
A reset is not possible. The PSM detected a fatal hard- or software error. |
|
Possible Causes |
Solutions |
|---|---|
|
The firmware update was not succesfully. |
Switch off the mains voltage and the 24V-supply. Switch on them again and start a new firmware update. If this error happens repeatedly, please contact your competent Beckhoff office. |