Axis modules and capacitor modules

Axis modules and capacitor modules 1:
►On all relevant modules, slide the bar for the AX bridge [1] to the right

The contacts can then no longer be seen.

►Screw screws once again into the control cabinet mounting plate in accordance with the drilling pattern


Axis modules and capacitor modules 2:
►Place the axis module [1] at the right side of the power supply module [2] onto the screw [3] and carefully press against the mounting plate [4]


Axis modules and capacitor modules 3:
►Once again, guide the screws [1] through the rectangular cut-outs in the module housing [2]


Axis modules and capacitor modules 4:
►Make sure that the plates of the rear panel of Module [1] are not overlapping and that the modules are sitting flush in cut-out [2].


Axis modules and capacitor modules 5:
►Bay further modules [2] and screw all remaining screws [1] and [3] tight on the module housings
►Observe tightening torques:

Components

Tightening torque [Nm]

Screws M5 x 5
Strength class 8.8

6


Axis modules and capacitor modules 6:
►On all modules that you wish to connect, open the quick connectors [1] and place them in the 90° position


Axis modules and capacitor modules 7:
►Slide all bars [2] for the AX bridge to the left
►Close all quick connectors again

The modules are now connected to one another.