Error reset (command S-0-0099)

After rectifying an error, it is necessary to perform an error reset. The associated command is the IDN S-0-0099. This command can also be given directly via the display. As soon as an error occurs the display flashes continuously; the standard display is shown again and the flashing stops only after a successful error reset.

Overview

Error reset (command S-0-0099) 1:

Executing the command

Press the right side of the rocker Error reset (command S-0-0099) 2: 3x until the following display appears: Error reset (command S-0-0099) 3:

Display

Description

Error reset (command S-0-0099) 4:

1 = "M" indicates that the "menu mode" is activated.
2 = The "Reset" menu is active.
3 = Indicates which channel of the AX5000 the reset affects.

There are now 2 possibilities:

Press the center of the rocker Error reset (command S-0-0099) 5: for approx. 3 sec. to execute the reset command for channel "A"
or
Press the upper or lower side of the rocker Error reset (command S-0-0099) 6: and switch to channel "B". Now press the center of the rocker Error reset (command S-0-0099) 7: for approx. 3 seconds and execute the Reset command for channel "B". The following display appears Error reset (command S-0-0099) 8:.

The standard display should appear again after approximately 25 seconds. If the error display is still visible after that, this means that you have not rectified the cause of the error, or that there are further errors.