Cyclic values

The two lines with the cyclic values displayed on the standard display are configurable. You can select cyclic values to be shown in the standard display from a list stored in the firmware. The procedure for configuring line 1 and line 2 is identical:

Overview (example)

Changing the display

Starting from the standard display, press the right side of the rocker Cyclic values 2: once (for line 1) or twice (for line 2), and the display Cyclic values 3: or Cyclic values 4: appears.

Display on the AX5000	Description
	1 = "M" indicates that the "menu mode" is activated. 2 = The "CycValuesLine1" menu is active. The value to be displayed in line 1 can thus be selected 3 = Indicates which cyclic value is currently displayed.

The currently displayed value determines the point of entry into the list of the cyclic values. Use the lower Cyclic values 6: or upper Cyclic values 7: side of the rocker to switch to the next cyclic value. If the desired value has been reached, press the center Cyclic values 8: of the rocker for 3 seconds. The value is accepted and the changed standard display is shown.