Special safety notes on braking resistors

The responsible staff must ensure that the application or use of the products described satisfy all the security requirements, including all the relevant laws, regulations and guidelines.

DANGER

Serious risk of injury through electric shock!

Due to the DC link capacitors, the DC link contacts "DC+ and DC-" and "RB+ and RB-" may be subject to dangerous voltages exceeding 875 VDC, even after the servo drive was disconnected from the supply network.
Wait 5 minutes for the AX5101 - AX5125 and AX520x; 15 minutes for the AX5140/AX5160/AX5172; 30 minutes for the AX5190/AX5191; 45 minutes for the AX5192/AX5193 after disconnecting, and measure the voltage at the DC links "DC+ and DC-". The device is safe once the voltage has fallen below 50 V.

WARNING

Caution - Risk of injury through hot surfaces!

The temperature of the braking resistor housing surface may reach over 200 °C. Please ensure that the housing has cooled down below 40 °C before touching it.

NOTICE

Special safety notes on braking resistors 1:

UL and CSA approvals.

The braking resistors in the AX2090-BW5x-xxxx series are UL and CSA approved. You can therefore operate the braking resistors in all commercial areas that require UL and CSA approval.