F72C, Feedback "general": Internal error
An internal error occurred while processing the feedback parameter data (command is not supported)
|
Diagnostic Code (Hex.) |
Diagnostic Code (Dez.) |
|---|---|
|
F72C |
63276 |
|
Class |
Type |
|---|---|
|
Error |
Command error |
|
Standard Reaction |
Reset |
|---|---|
|
Abort the procedure command execution. |
Execute Reset-Command (S-0-0099). |
|
Possible Causes |
Solutions |
|---|---|
|
No feedback system has been parametrized. |
Parameterize a feedback system. |
|
An unknown hard- or software error has occurred. |
Disconnect the servo drive from the mains (including the 24 V power supply) and start a new attempt. If this error occurs repeatedly, please call the Beckhoff branch office that is responsible for you. |