7112, Brake chopper overcurrent
Your connected brake resistor (internal or external) was overloaded.
Diagnostic Code (Hex.) | Diagnostic Code (Dez.) |
|---|---|
7112 | 28946 |
Class | Type |
|---|---|
Error | Error |
Standard Reaction | Reset |
|---|---|
Brake chopper is disabled | A reset is not possible. The PSM detected a fatal hardware or software error. |
Possible Causes | Solutions |
|---|---|
The connected brake resistor was placed under too much load. The brake resistor may be damaged. | Switch off the mains voltage and the 24 V supply. Check whether your brake resistor is damaged, if an external one is connected. Try to operate power supply module again. If this error happens repeatedly, please contact your Beckhoff office. |