Coil part

	Loss of force due to asymmetry Place the coil part symmetrically to the magnetic plate for the AL806x-1xxx series. For the AL8x2x, AL804x and AL806x-0xxx series, the coil part is positioned with an offset to the magnetic plate. Failure to observe this may result in loss of force at the linear motor and loss of performance in the machine or system.

	Dimensional drawings for alignment Please read the following chapters: "Technical data, paragraph AL802x, alignment AL802x" "Technical data, paragraph AL804x, alignment AL804x" "Technical data, paragraph AL806x-0, alignment AL806x-0" "Technical data, paragraph AL806x-1, alignment AL806x-1"

Mounting

►Clean the mounting surface on the coil part and on the machine carriage

►Insert locating pins [1] into the holes of the coil part [2]:

Locating pins
Tolerance zone	M6
Maximum screw depth	4 mm

►Place the machine carriage [3] with the holes on the locating pins [2] of the coil part

►Align the coil part, making sure that all the holes are aligned

►Insert the screws [4] and tighten them crosswise from inside to outside

Observe tightening torques:

Screw quality = strength class 8.8
Screw	M5 x 0.8
Recommended screw depth	5 mm
Maximum screw depth	6 mm
Tightening torque	6 Nm

►Place the assembled coil part including the machine carriage [5] on the guide carriage [6]

►Insert and tighten the screws [7]