AL806x horizontal

Before screwing the eyebolts into the coil unit, please observe the following instructions:

►Use thread on the upper side
►Use eyebolts according to DIN 580
►Note thread depths and screw depths for the threads in the coil unit
See Chapter Mechanical installation, section Assembly, coil unit
►Use washers if the set screws of the eyebolts are too long
►Use transport belts of the same length for each eyebolt so that the coil unit does not tilt

 

AL806x horizontal 1:
►Screw eyebolts [1] into the outer adjacent threads on the outer sides. Make sure to always choose the largest possible distance from each other