Attachment of the magnetic plates

Fastening the magnetic plate to the machine bed

Removing the protective plates

Proceed as follows:

• Align all the magnetic plates in the same direction.
  Example:
  All magnetic plates must be attached in such a way that the positioning holes point to the right upper corner.
• Fasten the magnetic plate to the machine bed. The minimum screw-in depth should be 6.5 mm. The tightening torque is 2.5 to 3.5 Nm.
• The other magnetic plates can now be assembled in a same way.

Proceed as follows:

• Remove all protective plates.
• Check that the carriage can move smoothly and without hindrance over the magnetic plates.
• The alignment of the magnetic plates should be checked if there are significant variations in the force when moving from one magnetic plate to the next.