Intended use
The planetary gear units from the AG3300 series may be operated only in the intended ambient and environmental conditions defined in this documentation.
The components are installed in plants or machines. Stand-alone operation of the components is not permitted.
The gear unit is intended for attachment to motors under the following conditions:
- The design of the motors is B5
- The concentricity tolerance or axial run-out tolerance conforms to EN 50347
- The cylindrical shaft end has the tolerance class h6 to k6
 | Observe the approvals for gear units with the Ex-marking Gear units marked with the Ex-marking comply with EU Directive 2014/34/EN; ATEX and are approved for use in potentially explosive atmospheres. The performance data are limited and can be found in the chapter: "Technical data" of this translation of the original instructions. Read the entire drive system documentation:
|
Further Information