System requirements

System requirements 1:

Check and update software version

The automatic securing of the end positions of the electric cylinder requires the following TwinCAT 3 Drive Manger 2 software version:
TE5950 | Version 1.1.45.0 or higher

Product defect possible, as the end positions may not be secured.

  • Check the software status of TwinCAT 3 Drive Manger 2.
  • Update to the required version.
System requirements 2:

Check and update software version

The automatic protection of the end positions of the electric cylinder requires at least one installed version of TwinCAT NC PTP.

  • Check the TwinCAT 3 software version to see if an NC PTP is available
  • If necessary, install TwinCAT 3 NC PTP (TF5000 or higher)
System requirements 3:

Check and update firmware version

The automatic securing of the end positions of the electric cylinder requires the following firmware version of the servo drive:
ELM72xx SW 2 Rev. 17 or higher

Risk of defect. The end positions may not be secured.

  • Check the firmware version of the servo drive
  • Update to the required version
System requirements 4:

TE5950 setup download

You can find the current setup file on the product website

TE5950 | TwinCAT 3 Drive Manager 2