IOF_SER_ResetErr

IOF_SER_ResetErr 1:

The “IOF_SER_ResetErr” function block clears the following errors of a SERCOS master:

The errors in the existing drives;
The diagnostic status in the diagnostics channel of the existing drives;
The system error;

VAR_INPUT

VAR_INPUT
    NETID     : T_AmsNetId;
    DEVICEID  : UDINT;
    RESET     : BOOL;
    TMOUT     : TIME := DEFAULT_ADS_TIMEOUT;
END_VAR

NETID: The network address of the TwinCAT computer on which the ADS command is to be executed can be entered here (type: T_AmsNetId). If it is to be run on the local computer, an empty string can be entered.

DEVICEID: The DeviceId is used to specify the SERCOS master whose errors are to be cleared. The device IDs are specified by the TwinCAT system during the hardware configuration.

RESET: the block is activated by a positive edge at this input.

TMOUT: States the length of the timeout that may not be exceeded during execution of the command.

VAR_OUTPUT

VAR_OUTPUT
    BUSY    : BOOL;
    ERR     : BOOL;
    ERRID   : UDINT;
END_VAR

BUSY: When the function block is activated this output is set. It remains set until a feedback is received.

ERR: If an error should occur during the transfer of the command, then this output is set once the BUSY output was reset.

ERRID: Supplies the ADS error number when the ERR output is set.

Requirements

Development environment	Target platform	IO hardware	PLC libraries to be integrated (category group)
TwinCAT v3.1.0	PC (x86)	Sercans SCS-P ISA; Sercans SCS-P PCI; Beckhoff FC750x PCI	Tc2_IoFunctions (IO)