Removing cables
Notice | |
Electrical voltage If the power supply is switched on during dismounting, this can lead to damage to the Embedded PCs.
|
 | Cabling Make a note of the wiring configuration, if you wish to restore it with another device. |
Before dismantling the embedded PC, shut down the embedded PC and switch off the power supply. Only then can you remove all the cables. Also remove all cables from the first terminal after the power supply terminal.
Requirements:
- Exit the software and shut down the embedded PC.
- Switch off the power supply.
Remove the cables as follows:
- 1. Remove the wiring from the basic CPU module, any system interfaces that may be connected and the extension modules.
- 2. Remove the wiring from the first terminal next to the power supply terminal.
- 3. Pull the orange strap to remove the first terminal after the power supply terminal by pulling it forward.
- In the next step the embedded PC can be removed from the DIN rail and dismantled.
