Special safety instructions for AX2090-NF80
The safety instructions are designed to avert danger and must be followed during installation, commissioning, production, troubleshooting, maintenance and trial or test assemblies.
The mains filter series AX2090-NF80 are not designed for stand-alone operation and must always be installed in a machine or system. After installation the additional documentation and safety instructions provided by the machine manufacturer must be read and followed.
The responsible staff must ensure that the application or use of the products described satisfy all the requirements for safety, including all the relevant laws, regulations and guidelines.
| |
Risk of injury! Electronic equipment is not fail-safe. The machine manufacturer is responsible for ensuring that the connected motors and the machine are brought into a safe state in the event of a fault in the drive system. |
Observe the discharge times of the capacitors
Observe the following delay times after disconnecting from the mains supply:
| 30 minutes |
| 30 minutes |
| 30 minutes |
Note: In the power supply module the control word can be set to "Fast discharge DC link" in object 0x8000:11. This can trigger a rapid discharge of the DC link when the mains voltage is switched off. This allows the waiting time to be bypassed. Please note the general conditions of the object.